I have a stereo unbalanced output - 1/4" TRS Stereo Jack - on my equipment so how do I connect it to my monitors?

Use the wiring conventions shown below. It is important that all of the connections are made otherwise there could be a loss of input signal level (e.g. XLR pin 3 left floating) or induced hum (e.g. chassis ground and audio ground connected together) due to ground loops.

Note: do not connect the XLR chassis to XLR pin 1, as this will compromise the RF immunity of the monitor's electronics.

TRS to 2x XLR

Mini plug to 2 XLR