How do I control the volume of GENELEC monitors?
There are many ways to control the volume of GENELEC monitors. Some of the ways we recommend are:- "Monitor" or "main L/R" output buss of your mixing desk
- Outputs of a surround sound decoder pre-am...
Which models in the GENELEC range are magnetically shielded?
2-Way Monitors
All Genelec 2-way monitors come with magnetic shielding as standard.
This was also provided on the following discontinued products:1029A, 1030A, 1031A, 2029A and 2029B
3-W...
No pre-amp outputs on my equipment - how do I connect the monitors to the speaker outputs of my power amplifier?
Yes and No. Do not connect the monitors directly to a power amplifier output, as the monitor's input stage will be damaged. Use the simple attenuator design shown below. Be sure to make all of the con...What sort of cable should I use for digital connections?
Will any analog audio cable work for this?
One should avoid using analog audio cables for AES/EBU digital audio if you have the choice. Use purpose built proper AES/EBU digital audio XLR-to-XLR cable...How do I connect more than one monitor to a single output?
The 8020A and 8030A monitors have an analogue XLR output connector which can be used to daisy-chain many units together. This output connection can be used for daisy-chaining up to six 8020A's or 8030...More Articles...
- I have a stereo unbalanced output - 1/4" TRS Stereo Jack - on my equipment so how do I connect it to my monitors?
- I have unbalanced outputs - RCA or 1/4" Mono Jack - on my equipment so how do I connect them?
- I have balanced outputs - XLR or 1/4" TRS Stereo Jack - on my equipment so how do I connect them?
General
