Technical Specifications
SPL
114 dB
Amplifier Power
250 W Bass (Class D) + 150 W Treble (Class D)
Frequency Response
33 Hz - 23 kHz ("-6 dB")
Accuracy of Frequency Response
± 2.5 dB (40 Hz - 20 kHz)
Driver Dimensions
⌀ 250 mm Bass + ⌀ 25 mm Treble (view in inches)
Dimensions
H 495 x W 320 x D 290 mm, (view in inches)
Weight
17 kg / 37.5 lb
Connections
1 x XLR Analog Input
1 x XLR AES/EBU Input
1 x XLR AES/EBU Output
2 x RJ45 Control
1032C
SAM™ Studio Monitor
Technical Specifications
The 1032C is a high-SPL nearfield monitor that fuses the much-loved soffit-mountable styling of the iconic 1000 series with our latest Smart Active Monitoring technology.
System Specifications
Frequency Response
40 Hz - 20 kHz (± 2.5 dB)
Low cutoff -6dB
33 Hz
High cutoff -6dB
23 kHz
SPL
Peak SPL Maximum peak acoustic output per pair in a listening room with music material at 1 m.
≥124 dB
Short term max SPL Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz at 1 m.
≥114 dB
Long term max SPL Maximum long term RMS acoustic output in the same conditions with IEC weighted noise (limited by driver protection circuit) at 1 m.
≥104 dB
Self-generated noise
Self-generated noise Self generated noise level in free space at 1 m on axis (A-weighted).
≤5 dB SPL
Weight
Weight17 kg (37.5 lb)
Dimensions
Height
495 mm
Width
320 mm
Depth
290 mm
Enclosure
Enclosure material
MDF
Drivers
Driver type
Cone
Magnetically shielded bass driver.
Diameter
250 mm
Driver type
Metal dome
Magnetically shielded treble driver.
Diameter
25 mm
Directivity
Harmonic distortion
> 100 Hz ≤0.5 %
Group delay
The latency at high frequencies from the input to the acoustic output, measured in the analog input:
Extended Phase Linearity in GLM set to OFF
3.2 ms
In Genelec performance graphics, the time of converting the from an electronic input signal to the acoustic output in a Genelec monitor is described by two factors – latency and group delay. The group delay factor can be read in the graphics for a specific frequency. The total frequency-specific input-to-output delay is a sum of the latency and group delay factors. To understand the significance of this total delay, consider that moving a loudspeaker away by 1 meter creates an additional delay of about 3 ms.
Amplifier Section
Amplifiers
250 W Class D
150 W Class D
Mains voltage
100-240 VAC 50/60Hz
Power consumption
ISS Active
≤1 W
Idle
≤11 W
Full output
200 W
Signal processing section
Connectors
Input Analog signal input connector XLR female, balanced 10 kOhm.
Input Digital signal input connector XLR female 110 Ohm.
Output Digital signal output / Thru connector XLR male 110 Ohm.
2 x Control Two CAT5 (RJ45) GLM Network connectors for computer control using the Genelec Loudspeaker Manager (GLM) software.